Die Covers are the custom designed insulation blankets made for your die by Insul-Vest®. They eliminate cold spots, nullify the affects of environmental factors on your heat profile, cut your heat soak time in half and eliminate up to 80% of your electrical energy cost used to maintain your die heat. When installed the potential safety hazard of a hot piece of equipment is nearly eliminated.

Insul-VestDie Covers are fabricated with properly located openings, holes and exit slits to allow for adjusting bolts, thermocouples, wiring, etc. The custom jackets are made in user friendly sections using a high temperature fastening systems for ease of installation.

Benefits and Features of Insul-Vest Die Covers™

• Improves heat profile that are so critical on film dies.
• Isolates mold from shop environmental effects such as open doors or fans.
• Reduces die heat up time by up to 50%.
• Reduces energy used for die heating by 30-80%.
• Improves safety by lessening exposure to burns and electrical shock.
• Outer layer (cold face) made of Fiberlon, (Teflon® coated fiberglass). Plastic will not stick to it!
• Inner layer (hot face) made of silica fabric will withstand up to 1800°F.
• Insulation material made of ceramic fiber will withstand up to 2300°F.
• Packaged as a complete set for each of your individual dies.
• Easy to install design using High-Temperature Velcro® fasteners.
• I.D. patch identifies each Die Cover™ location easing re-installation.
• Each Die Cover™ is stamped with a part number to ease re-ordering.
• Our covers can also help insulate Pipe Die and Y Blocks.
  

You can use the guide below to measure your dies for Insul-Vest Die Covers.